







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Fast, Reliable Fence Installation Across Richland Hills
If you’re planning a fence in Richland Hills, you already know the lots are tight and the trees are old. Most of this city was built out between the 1950s and 1970s, and there’s no greenfield left to start fresh on. That changes how a fence gets set. We work with independent local pros who know the difference between a clean run along a survey line and a post that lands squarely in a pecan root. Call (855) 720-1779 and we’ll get your free estimate moving.
Why Richland Hills Homeowners Call Construction Denton for Fence Installation

We connect homeowners here with vetted local fence professionals who do this work in Richland Hills specifically, not a crew staging from across the metroplex guessing at yard grades. The pros we work with carry the state licensing and insurance their trade requires, and the estimate you get is written line by line so the number holds once work starts.
Our technicians have up to 9 years of experience, and that matters on a narrow lot where the survey stakes have wandered. A fence that looks straight from the alley can sit six inches off the record line. We treat that as a survey question, not a guess, because encroachment disputes in tightly packed post-war subdivisions are real and expensive to unwind. If a neighbor’s fence has drifted over decades, the pro walks the line with you before a single hole is dug.
Response into Richland Hills is quick, and the phone is answered whenever you call. The local knowledge here is specific: expansive clay, mature canopy, and footings that have to go deeper than a generic install guide ever mentions.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Our Fence Installation Services in Richland Hills
Fence work in Richland Hills leans heavily toward privacy and repair, because most yards are already fenced and the existing runs are aging out. Here’s where we focus.
Wood Fence Installation in Richland Hills
A wood fence is still the default choice on these narrow, tree-heavy lots, and for good reason: it’s repairable board by board when hail or a leaning post takes out a section. The trick in Richland Hills is air circulation. Wood run tight against a mature pecan traps moisture against the trunk and rots the pickets from the inside out, so the layout has to breathe.

Privacy Fence Installation in Richland Hills
When a two-story addition next door suddenly looks straight into your backyard, a privacy fence is the fix. Height is the question here: anything over six feet, or any fence enclosing a pool, typically triggers a permit, and the inspector will look at setbacks and footing depth. We build the plan around your lot, not a stock drawing.

Fence Repair in Richland Hills
Clay soil moves, and posts set in shallow footings crack and lean as moisture cycles through the year. A repair can often save a run that a replacement quote would throw away, but not always. We tell you honestly which one your fence is asking for. If you’d rather see the full scope of options, our fence installation hub lays out every material and path.

Chain Link Fence Installation in Richland Hills
Chain link still has a place on the utility side of the yard, especially where budget matters more than looks. The one caution: never set a new chain link over a line nobody surveyed. In a fully built-out suburb like this, that’s how encroachment arguments start.
Aluminum and Vinyl Fencing in Richland Hills
Homeowners upgrading from aging wood often look at vinyl or aluminum. A Bufftech vinyl privacy panel handles heat and moisture without the rot wood fights, and an Ameristar aluminum run gives you an open, ornamental look that won’t rust. Both are strong against North Texas sun and the occasional hail.
Trusted Brands We Work With in Richland Hills
The material you pick drives how long a fence lasts here. We work with established lines like Bufftech for vinyl and Ameristar for ornamental aluminum, plus ActiveYards and Jerith where the design calls for them. We don’t stock parts and we don’t run trucks out of a local yard. The local pro orders the material for your job, so turnaround is fast and you’re not limited to whatever happened to be sitting in inventory. You choose the finish, the pro handles the rest.
Common Fence Installation Problems We See in Richland Hills Homes
This city’s age and its soil create a predictable set of failure modes. Here’s what we watch for.
- Leaning posts on shallow footings. Concrete set too shallow cracks and heaves as expansive clay swells and shrinks with North Texas moisture. By the time a post leans, the footing has usually failed, not the wood.
- Wood rotting against mature pecan trees. A privacy fence built tight to a trunk traps damp air and damages roots on both sides. The fence dies early and the tree suffers too.
- Chain link on an unsurveyed property line. Decades of undocumented fence shifts mean the physical line and the record line don’t match. Building over the old one locks in a dispute.
- Footings that ignore the root zone. Cutting a critical root zone to sink a post can kill a mature tree slowly over years. Layout should route around it, not through it.
See the difference
Before
After
Before
After
Before
AfterHow a Typical Richland Hills Fence Project Actually Goes
A common version of this job starts with a homeowner wanting a privacy fence to block views from a new two-story addition next door. During the pre-installation inspection, the contractor finds the existing chain link was set directly over the root zone of a mature pecan, and the clay soil has heaved the original footings until they cracked. A qualified local pro recommends a layout that avoids the critical root zones, uses deeper footings built for clay, and pulls the permits, especially when the fence encloses a pool or rises above six feet. Any surprise found once work begins gets priced and approved in writing before a post goes in.
Pricing for Fence Installation in Richland Hills, TX
These are typical estimated ranges for the Richland Hills market. The written estimate sets the final price, and the estimate is free. A typical vinyl fence installation in Richland Hills runs $3,500 – $9,000, and aluminum lands at $4,000 – $10,000 depending on linear feet, height, and how much footing work the clay demands. Tight lots with alley access and mature trees can add labor on staging alone, and root-safe layouts sometimes mean routing around what a cheaper crew would cut through. Here’s how the two most-requested materials price out.
| Service | Typical Estimated Range |
|---|---|
| Vinyl Fence Installation | $3,500 – $9,000 |
| Aluminum Fence Installation | $4,000 – $10,000 |
Wood and repair pricing gets quoted per job once the run is measured and the footings assessed. Call (855) 720-1779 for a free, written, line-item estimate.
We Also Serve Cities Near Richland Hills
Richland Hills sits right in the middle of a cluster of inner-ring suburbs, and we connect homeowners across the surrounding area too. That includes Hurst, North Richland Hills, Haltom City, and Watauga. The soil and the housing stock don’t change much from one to the next, so the same survey-first, root-aware approach travels with the work.
Serving Richland Hills, TX – Our Local Coverage Area
We serve Richland Hills and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Fence Installation in Richland Hills
Most fences over six feet tall, and any fence enclosing a pool, typically require a permit in Richland Hills, and the inspection checks footing depth, setbacks, and height. Pulling the permit is part of the job, and the local pro handles it. Call (855) 720-1779 and we’ll confirm what your specific fence needs.
The pro lays out the run around the tree’s critical root zone rather than through it, then deepens the footings where the clay demands. Cutting a root zone to fit a straight line can kill a mature tree over time, so the layout flexes instead. Call (855) 720-1779 for a free walkthrough.
A repair makes sense when the posts are sound and the damage is isolated to boards or panels. When footings have failed and posts are leaning, replacement usually costs less over the long run than repeated fixes. The estimate tells you which one your fence needs, and it’s free. Call (855) 720-1779.
Yes. Narrow lots with alley access are the standard here, and the plan accounts for both: setbacks against the code, and a staging plan that keeps equipment off the alley traffic. Call (855) 720-1779 and we’ll map it out.
Vinyl and aluminum generally hold up best against heat, moisture, and hail because neither rots or rusts, and both tolerate the soil movement. Wood remains repairable and a good value when footings are done right. Call (855) 720-1779 for an exact quote, and estimates are free.
Whether you’re replacing a leaning wood run or starting fresh with vinyl or aluminum, the first step is a free estimate. Call (855) 720-1779 to schedule yours. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. The written estimate sets the price, permits get pulled, and any surprise gets approved in writing before we touch a post.
Written by the team at Construction Denton.












